It’s been a while in development, but I’ve eventually got to a solid and tested version of my dual-screen mount that uses the original Wattbike Atom bracket.
I’m really happy with the design and solution now. I have tested this thoroughly over the last two weeks, making small teaks and one big one! It’s been a challenge after setting off in a direction and then making a 360 turn halfway through the development.
What I’ve learnt is that if it’s not working, then don’t be afraid to scrap your current direction and start again – taking what you have learnt into the new version – and it’ll be better – in theis case, a lot better!
See my shop for my final design. The early testers have been over the moon with the fit, finish and all-important function. This solution is so much more flexible than anything I can see in the current marketplace.
I hope you like what I’ve done. This project started as a totally personal project and has organically spread into a low-volume solution based around people with the same requirement.
Off to set the printer off – again!|
Ian